03/01/2017

Diệp Mẫu


1 nhận xét:

  1. Any gap there'll lead to clogs ultimately because the melted filament will leak out around the outdoors of the liner causing the liner’s inside diameter to deform and reduce. Modify your begin code in your slicer to add some extra priming. While you’re checking the codes, certain you|ensure you|be positive to} don’t have an extreme retract in your finish code. Under best straw hats for men extrusion in generalMake positive your filament can unspool freely from the reel. To enhance chamber or ambient air temperature – enhance the room or chamber temperature in 5°C increments reduce back} the difference in temperature and therefor the tendency to warp. Usually it starts within the corners and might progress if the print isn’t stopped.

    Trả lờiXóa